Transmitter Selection Menu and Batteries
1. Ensure number in globe icon on transmitter matches that
on the receiver startup screen.
2. Install batteries. Dual-frequency transmitter batteries must be
loaded with transmitter in proper orientation (pointing up or
down) to set the desired frequency.
3. Use Transmitter Selection option on Main menu to select
transmitter type and frequency.
Transmitter Selection Menu
Calibration Menu
Only calibrate with transmitter in housing and in an
interference-free environment. Verify calibration daily.
1. Place transmitter in housing on
level ground 3 m from receiver
(measure from inside edge of
receiver as shown).
2. Record signal strength.
3. Select 1-pt calibration from
calibration menu and follow the
instructions.
4. Verify calibration by moving the receiver ±1.5 m, then holding the
trigger to take a depth/distance reading.
To Next Page
Loading...
