Power On Remote Display
1. Install the battery pack or connect to a
DC power source.
2. Connect the antenna.
3. Press Execute for two seconds;
display enters the Remote Mode
locating screen.
4. Press the Down arrow to access the
Main menu.
Remote Display Main Menu
Use the arrow buttons to highlight menu options and Execute to
select. Use Remote Mode during drilling.
Use the Settings menu to set items such as telemetry channel and
display units to match those on receiver.
Remote Mode Locating Screen
For other DigiTrak displays, see separate manual or Quick Start Guide.
Watch our DigiTrak Training Videos at
http://www.youtube.com/dcikent
To Previous Page
Loading...
