DigiTrak Falcon F1 - Locate Screen Shortcuts; Depth Screen

DIGITALCONTROLINCORPORATED
DigiTrak Falcon F1™ Operator's Manual 31
Locate Screen Shortcuts
The following shortcuts are available from the Locate screen.
Task Operation Page
Depth Screen Hold trigger at locate line (LL) 31
Max Mode Hold trigger at least five seconds 32
Main Menu Click trigger 12
Predicted Depth Screen Hold trigger at front locate point (FLP) 32
Screen Contrast Hold trigger with receiver vertical 11
Less Common Icons
1. Transmitter yaw
2. Transmitter (Tx) current draw warning
3. Tx battery strength
4. Target Steering
5. Calibration required or self-test error
warning
6. Attenuated Signal (shallow depth or
excessive interference)
7. Roll Offset menu enabled
8. When flashing, indicates severe
interference
Locate Screen with Less Common Icons
Depth Screen
Hold the trigger with the receiver at the locate line (LL) to display the
Depth screen.
Locate Points (FLP & RLP) and
Locate Line (LL)
Page37
1. Locate point (front or rear)
2. Bird's-eye view
3. Locate line (LL)
4. Height-Above-Ground (HAG)
setting on
5. Ground level
6. Transmitter depth
7. Tx battery strength
Depth Screen at LL with HAG On
When the HAG setting is disabled, the receiver will be shown on the
ground and must be placed on the ground during depth readings.
Height-Above-Ground (HAG)
Page16