DigiTrak Falcon F1 - Table of Contents

DIGITALCONTROLINCORPORATED
DigiTrak Falcon F1™ Operator's Manual v
Table of Contents
Important Safety Instructions 1
General 1
Pre-Drilling Testing 2
Interference 2
Potential Interference Received 2
Potential Interference Generated 2
Battery Pack Storage 3
Equipment Maintenance 3
General Transmitter Care Instructions 3
Getting Started 5
Introduction 5
Using This Manual 6
Powering On 6
Receiver 7
Transmitter 7
Remote Display (FCD) 7
Setup Summary 7
Select Frequency Optimizer 7
Pair with Transmitter 8
Interference Check 8
Calibrate 8
Above Ground Range Check 8
Receiver 9
Overview 9
Trigger Switch 9
Audible Tones 10
Startup Screen 10
Adjusting Screen Contrast 11
Your Remote Display 11
Receiver Menus 12
Frequency Optimizer 12
So I Just Paired, Now What? 16
Power Off 16
Height-Above-Ground (HAG) 16
Turn HAG On 17
Turn HAG Off 17
Set HAG Value 18
Calibration and AGR 18
1-Point Calibration 19
Above Ground Range (AGR) 21
50 Foot Calibration (Optional) 22
Settings 22
Depth Units Menu 23
Pitch Units Menu 23