DIGITALCONTROLINCORPORATED
4 DigiTrak Falcon F5
®
Operator's Manual
Before use, inspect the battery cap O-ring for damage that may allow water to enter the battery compartment.
Replace the O-ring if the one installed becomes damaged.
Do not use chemicals to clean the transmitter.
Placing tape around the fiberglass tube of the transmitter, if space allows, will keep the fiberglass protected
from most corrosive and abrasive environmental wear. Do not tape over the IR port as this will interfere with
IR communication.
Falcon 19- and 15-inch transmitters have a threaded hole (1/4”-20 thread) in the battery cap to allow the use
of an insertion/extraction tool for installing and removing the transmitters in end-load housings. Ensure this
hole remains clear of debris.
Send in the Product Registration Card or register online at access.DigiTrak.com within 90 days of purchase
to enable the warranty on your equipment, including a 3-year/500-hour warranty on your transmitter. Ask your
dealer about our extended 5-year/750-hour transmitter warranty.
To Next Page
Loading...
