DigiTrak FALCON F5 - Roll Offset Functionality; Enabling Roll Offset

DIGITALCONTROLINCORPORATED
22 DigiTrak Falcon F5
®
Operator's Manual
Roll Offset Menu
Enable Roll Offset
1. Select Set and enable the roll offset.
1. Set and enable the roll offset
2. Disable roll offset
Roll Offset Menu
2. Ensure the drill head is at its 12:00 position and that the transmitter is on.
1. Transmitter’s true roll position with
housing at 12:00
2. Set the roll offset
Set Roll Offset Menu
3. Select Set the roll offset.
If you need to know the original roll value later (perhaps to change a transmitter frequency in-bore as
discussed on page62), simply toggle to the Roll Offset option in the Settings menu, and if Roll Offset is
enabled, the original roll value displays at the bottom of the screen after "Roll offset enabled".
When the roll offset function is enabled, the roll indicator will change to a circle and RO appears at the bottom
left of the roll indicator. RO will also appear on the remote display.
Roll Offset Enabled