DigiTrak FALCON F5 - Appendix B: Receiver Screen Symbols

DIGITALCONTROLINCORPORATED
DigiTrak Falcon F5
®
Operator's Manual 67
AppendixB: Receiver Screen Symbols
Symbol Description
A
Attenuated Signal – Indicates signal attenuation is in effect due to the presence of excessive
interference, or when locating within 1 m of the transmitter. The receiver automatically attenuates
the transmitter signal when locating at shallow depths to reduce excessive signal strength. The A
displays at the bottom left of the frequency optimizer results (page25) or at the top right of the roll
indicator (page36) on the locate screen. Attenuation while locating in close proximity to the
transmitter is normal; attenuation during calibration or frequency optimization is a warning to
relocate to a location with less interference. The receiver will not calibrate when the signal
strength is flashing red, indicating the presence of extreme interference.Page13
Band Up or Down – Indicates whether the receiver is currently using the Up or Down optimized
band. Located in the title bar of the Locate screen.Page12
Calibration Signal High – Displays after a failed calibration, often because the transmitter is too
close to the receiver.Page15
Calibration Signal Low – Displays after a failed calibration, often because the transmitter is not
powered on or is on a different (Up or Down) frequency band than the receiver.Page15
Calibration Attenuation Error – Displays after a failed calibration. If attenuation is in effect due to
only moderate interference, the system will still calibrate; however, it is best practice to relocate to
a quieter location where attenuation is not in effect. If the signal strength on the locate screen is
flashing red, this indicates extreme interference, and a calibration will fail.Page14
Globe Icon – Shown on the receiver startup screen, the number inside (shown blank here)
identifies the regional designation, which must match that on the transmitter battery
compartment.Page6
Ground Level – Represents the ground for the HAG function, depth readings, and the in-ground
calibration procedure.Page37
Locate Line – The locate line (LL) always displays perpendicular to the transmitter. The locate
line (LL) is found between the front and rear locate points only after a reference lock (see below)
has been obtained. May also include the transmitter yaw angle in degrees.Page37
,
Locating Ball/Target – Represents the front and rear locate points (FLP and RLP). When the
locate line appears, the locating ball will become a solid circle (ball) representing the approximate
locate point.Page36
Locating Icon (the receiver) – Represents a bird’s-eye view of the receiver. The square at the top
of this icon is referred to as the “box” in the terms Ball-in-the-Box and Line-in-the-Box
locating.Page36
Max Mode – Max Mode begins when the trigger is held longer that five seconds during a depth
reading.Page37
Max Mode Timer – Provides a visual indication that Max Mode is active (trigger held). Replaces
the roll/pitch update meter. It will remain red if no stable signal can be found.Page37
Pitch Assumed Zero – Indicates that since no pitch data is currently available, the pitch is
assumed to be zero for depth, predicted depth, and AGR calculations.Page37
Pressure – When using a fluid pressure transmitter, the number next to this icon on the Locate
screen indicates the pressure reading. If the pressure reaches an over-limit condition (from 689–
1724 kPa), the value will appear red. When the pressure reaches the overload condition (over
1724 kPa), the value will display as “+OL”.Page23
Receiver Battery Strength – Shows the remaining battery life of the receiver. Appears above the
main menu. When battery life is low, the icon will flash on the Locate screen.Page12
Receiver Icon – Indicates the position of the receiver relative to the ground for the HAG function,
depth readings, in-ground calibration, and the Target Steering function.Page37