© 2020 Digitrax, Inc. www.digitrax.com
25
25
7.3.6 Duplex settings Editor (DT602D)
If a DT602D is plugged into LocoNet, in the
Utility Task screen press the key. DT602D
Duplex-enabled throttles will show the Duplex
Edit screen, allowing Duplex setting modication.
1. Follow the prompt scroll to select and modify
the Duplex settings wanted.
2. When complete press the “Update” key to
write the new settings to the LocoNet system.
3. A Key value 0000 turns OFF the joining pass-
key# requirement.
8.0 Emergency Stop
To stop everything on a powered layout immediately:
Press the key then the key to turn o track power to the whole layout.
This option will stop everything on the layout, without knowing what locomo-
tive is on which throttle, or the need to actively control the speed of any loco-
motive.
Do not turn Track Power o during a short circuit. Clear the short rst.
To Emergency Stop the active knob controlling a locomotive: Press and
hold down the key for about one second and the speed will go to zero and
the throttle will beep. The release the key, or hold down for another about
1/2 second to also emergency stop a locomotive controlled on the other DT602
knob.
Having Trouble Stopping? If the deceleration CV value you set for a partic-
ular loco is very large, this can make it look like the loco is not stopping on
command because the deceleration CV value is causing the loco to take a long
time to come to a stop. Emergency stop commands force an immediate stop
with no deceleration delays.
Duplex Info Edit:
RF Net Name: Club_Net
Channel #: 15
Key#: 4567
IR ID#: 01
Update
To Next Page
Loading...
