Digitronic DIGISPEED DS1/V2 - The Status Leds; 6 Recovery Time for the DIGISPEED-DS2

Digitronic Digitaler Schaltbeschleuniger
Automationsanlagen GmbH DIGISPEED DS1/V2
5.1. The status LEDs
The DIGISPEED is equiped with 7 status LEDs, that light the terminal
allocation under the transparent sheet from behind. For every LED a specific
symbol was printed on the connection allocation.
Four LEDs show the actual status of the inputs. These are: Inp.1, Inp. 2, Cfg.
1 and Cfg. 2.
Two more LEDs show the actual status of the outputs. These are: Out. 1 and
Out. 2.
The last LED named Pow. displays the devices status.
Device starts.
Status OK.
Error output 1
Error output 2
Error output 1+2
6. Recovery time for the DIGISPEED-DS2
The recovery time for the DIGISPEED-DS2 is needed for the continous recharging of the condenser to
create the overload amplifier impulse, since after every initiation of such a surge impulse, the
condenser has to recharge itself first. This means, that between two consecutive overload amplifier
impulses, you have to wait for at least the time given in the table below.
Current (mA)Ü-Zeit* 1 msÜ-Zeit* 2 msÜ-Zeit* 5 msÜ-Zeit* 10 ms
100 4 ms 8 ms 20 ms 40 ms
200 8 ms 16 ms 40 ms 80 ms
300 12 ms 24 ms 60 ms 120 ms
400 16 ms 32 ms 80 ms 160 ms
500 20 ms 40 ms 100 ms 200 ms
600 24 ms 48 ms 120 ms 240 ms
700 28 ms 56 ms 140 ms 280 ms
800 32 ms 64 ms 160 ms 320 ms
900 36 ms 72 ms 180 ms 360 ms
1000 40 ms 80 ms 200 ms 400 ms
*Ü-Zeit:Duration of the over-energizing impulse
Ausgabe: August 04 Seite: 12
2 rue René Laennec 51500 Taissy France
Fax: 03 26 85 19 08, Tel : 03 26 82 49 29
E-mail:hvssystem@hvssystem.com
Site web : www.hvssystem.com