20
Wizard
Wizard is a configuration program that can assist you in setting up the necessary parameters
for your print server device to function. Setup a print server by using Wizard.
TCP/IP Wizard
1. Click Wizard button just like a picture ＜ ＞ .and select TCP/IP Wizard.
2 Select “Obtain an IP address from DHCP server”. If there is a DHCP server on your
network. This option allows the print server to obtain IP-related settings automatically
from your DHCP server. This setting, by default, is disabled. If you would like to
manually specify an IP address to the device, please skip to the following step.
3 In the IP Address option, type an IP address for the print server. The IP address must
meet the IP addressing requirements of the network segment.
To Next Page
Loading...
Need help?
General
