EasyManua.ls Logo

Digitus DN-13003-1 - Network Print Monitor Setup; Preparation and Protocol Selection

Digitus DN-13003-1
79 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6. Network Print Monitor
Preparation
The print server supports TCP/IP, IPX/SPX and NetBEUI protocols under Windows
computer. Please make sure that the following steps have been completed before
proceeding with installation under Windows 95/98/ME/NT4/2000/XP 32bit edition/server
2003 32bit edition.
Select A Desired Protocol
TCP/IP
The TCP/IP Protocol must be installed. For further information, please read “TCP/IP
Protocol Installation” section in this chapter.
Note: If TCP/IP protocol is chosen, please refer to “Assigning an IP Address to the print
server” section later in this chapter.
IPX/SPX
The IPX/SPX-compatible Protocol must be installed. For further information, please read
IPX/SPX-compatible Protocol Installation” section in this chapter.
NetBEUI
The NetBEUI protocol must be installed. For further information, please read “NetBEUI
Protocol Installation” section in this chapter. The Windows XP/2003/Vista/7 does not support
the NetBEUI printing.

Table of Contents

Other manuals for Digitus DN-13003-1

Related product manuals