snmp.snmpEnableAuthenTraps
Enables or disables the function of sending SNMP
Authentication Failure trap message to the network
administrator, if the community name within a SNMP
request is not correct.
Users can set up print server’s SNMP functions by using their browsers.
1.Click Setup, it then appears the sub-menu.
2.Click SNMP, it then as shown in the following picture.
SNMP Community:
The print server supports up to two community names. The default community
name is public (case-sensitive), with Read Only access right in default.
Support HP WebJetAdmin:
This option allows user determine to disable/enable the Support HP
WebJetAdmin.
SNMP Traps:
Enable the function of sending SNMP Authentication Failure trap message to
the network administrator, if the community name within a SNMP request is not
correct.
To Next Page
Loading...
