78
1. Check the network cabling, especially from the workstation running the PSAdmin to
the print server unit.
2. Run the PSAdmin and upgrade the print server again.
Question D
The Status LED light keeps blinking after POST.
Possible explanation and solution
The last upgrade process was not completed. The print server must be upgraded again by
using the PSAdmin. Please see Chapter 3 for details.
Question E
The PSAdmin reports “Create Print server Error”, “Create Printer Error”, or “Create Print
Queue Error” while using Auto Setup.
Possible Explanation
The print server name, the printer name, or the print queue name you specified in the Auto
Setup dialogue box contains a space.
Solution
Check to see if there is a space in the print server name, the printer name, or the queue
name. Type in a new name without a space between two characters or replace a space by a
dash (-) or an underscore (_).
Question F
The PSAdmin reports “Print server Already Exists”, “Printer Already Exists”, or “Print Queue
Already Exists” after specifying the print server name, or the print queue name in Auto Setup.
Possible Explanation
A same print server name or queue names exists in the specific NetWare file server as the
one you specified in the Auto Setup dialogue box.
Solution
Specify a new print server name or queue name in the Auto Setup.
To Next Page
Loading...
Need help?
General
