Digium, Inc. Page 31
Chapter 2: Unit Installation
Connecting Ports
A description of each of the front panel connectors on a Gateway Series
appliance is available in the section titled Front Panel Identification on
page 19. Please refer to that section to determine what should be
connected to each connector.
Connections to a Gateway Series appliance should be made in the
following order.
1. Gigabit Ethernet
2. T1/E1 Port(s)
3. Power Cord
Caution
This unit must be connected to the Telecommunications
Network in your country using an approved line cord, e.g.: for
Australia use only line cords complying with ACA Technical
Standard TS008.
Caution
Connect only equipment approved for use in your specific
country to the telecommunications network voltage circuit
ports.
To Next Page
Loading...
