Digium TE420B - Page 43

Digium, Inc. Page 43
Chapter 3: Configuration
Signalling:
pri_cpe for CPE side
pri_net for NET side
If you have a T1 PRI, add these lines to the following lines of the sample
file.
signalling = pri_cpe
switchtype = national
group = 1
context = incoming
channel => 1-23
E1 PRI
signalling = pri_cpe
switchtype = euroisdn
context = incoming
channel => 1-15,17-31
You can also configure a T1 channel bank of phones
signalling = fxo_ks
group = 1
context = phones
channel => 1-24
E1 channel bank
signalling = fxo_ks
group = 1
context = phones
channel => 1-15,17-31
Note: More detailed troubleshooting information is provided on http://
www.asterisk.org.