Digium TE420B - Page 53

Digium, Inc. Page 53
Chapter 3: Configuration
3. Reboot into the new Linux kernel.
4. Uncomment the following line in linux/drivers/dahdi/
dahdi_config.h
of the DAHDI complete source package:
#define CONFIG_DAHDI_NET
5.
Rebuild DAHDI in order to compile the sethdlc utility. Then execute
the following commands from the DAHDI complete source directory:
# make sethdlc
# make install
6.
Load and configure the driver:
# modprobe wct4xxp
# dahdi_cfg
7.
Use sethdlc to bring up the interface:
# sethdlc hdlc0 cisco
8.
Assign the interface an address:
# ifconfig hdlc0 192.168.0.1 netmask 255.255.255.0