Digium, Inc. Page 60
Chapter 4: Troubleshooting
3. Navigate to the tools/ directory in your DAHDI complete source
directory and type:
# make tests
Followed by:
# ./patlooptest /dev/dahdi/1 60
The first argument in the patlooptest command is the device for the
channel number you want to test. You should always test the first
channel of a span. The second argument is the duration in seconds to
run the test.
This runs a pattern looptest for 60 seconds. If you receive any failures,
it is possible you have a bad card and will need to call Digium
Technical Support (+1.256.428.6161)
How can I enable more features?
To view all of the options available to add to your dial plan, type the
following commands from within Asterisk:
*CLI> core show applications
*CLI> core show functions
Digium also offers services to help configure and add features you might
need. Contact Digium Technical Support (+1.256.428.6161) for more
information.
To Next Page
Loading...
