Dillon EDjunior User Manual

EDjunior Dynamometer User Instructions 17
6.4 Displaying Peak Force
The EDjr will store the peak force applied until that reading is cleared. To display the
peak force applied to an EDjr, from the force measurement mode, press the Mode soft
key. The display changes to display mode #2 shown in Figure 6.1 which is the peak
display mode. The peak force is displayed. You can clear this by pressing the Clear soft
key.
Peak reading is maintained after instrument power off and will be recalled with the next
power-on. Peak reading may be lost if battery power is removed.
Figure 6.1 Display mode menu
Press the Mode soft key until the desired display mode is reached.
Peak force can only be reset to zero if live force is zero. Peak force will reset to match
live force.
Force
Peak Peak
Force
lbf
lbf lbf
lbf
0
0
0
0
Display #2Mode
Display Mode #1
Live force
reading
Peak force
reading
Arrow key
press
Mode key
press
Arrow key
press
Clear
Mode ConfigSetupUnits
Clear
Mode
Config
SetupUnits
ESC key
press
ESC key
press

Dillon EDjunior Specifications

General

Brand	Dillon
Model	EDjunior
Category	Measuring Instruments
Language	English