DIMLUX MAXI CONTROLLER EVO 1.2 - MENU & KEYS - Basic Functions; Basic Menu Overview; Basic Light Configuration

6 7
ENEN
MENU & KEYS MENU & KEYS
Basic Advanced Menu
Using
Advanced menu
Using
Basic menu
The controller has a basic and an advanced menu. This enables a very easy operation without the need to go through
the parameters that were set earlier. The basic menu only shows the most frequently used functions. All parameters can
be changed and set in the advanced menu. You can switch between the basic and the advanced menus by holding
down the SET key.
Basic keys
OFF/MODE
By pressing briey and repeatedly on the OFF/MODUS key, you can select:
Lights permanent off > Lights are permanently off.
Lights permanent on > Lights are always on.
Lights by timer on/off > Lights go ON/OFF using the timer.
There are also two short cut keys available:
When you press the MODEkey rst and then the MIN (–) key, the “Lights permanent off” starts to operate immediately.
If you press the PLUS (+) key after the MODE key, the “Lights permanent on” starts to operate immediately.
ESCAPE
By pressing briey and repeatedly on the ESCAPE key, you can select to show:
*LIGHT The current time, room temperature, light output and remaining time are displayed.
*CO2 The current and set CO2 value are displayed.
*AUX/FAN The current temperature and the set fan speed are displayed.
*VPD. The plant temperature, room temperature, relative humidity and the VPD are displayed.
Using the ESCAPE key will also enable you to leave the menu.
PLUS (+)
You can browse or increase the values by pressing this key briey and repeatedly.
MIN (-)
You can browse or decrease the values by pressing this key briey and repeatedly.
SET
Using this key, the menu is opened in order to change settings.
Basic light menu
The following parameters can be set in the basic light menu:
Current time
Timer ON/OFF
Type of ballast/light xture
Time
Time
05:51
Press the SET key briey: the current time will appear. By pressing the SET key again, the time can be set using the +
or – key. Pressing the ESCAPE key will return you to the Home screen.
Timer ON/OFF
Timer on/off
8:00 till 20:00
Press the SET key shortly and navigate through the menu using the + or – key, until ‘Timer ON/OFF’ appears on the
screen. Pressing the SET key again will allow you to set the ON and OFF times.
Type of ballast/light xture
Press the SET key briey and navigate through the menu using the + or – key, until “output-power” appears on the
screen. By pressing the SET key again, you can select by using the + or – key which light xture you wish to control:
315 Watt (CDM lamp)
400watt (hps of hpi)
600watt (hps/niet EL) ook wel 230volt lamp genoemd
600watt EL UHF (hps/EL UHF) ook wel 400volt lamp genoemd
630watt DUAL (2x315watt cdm)
1000watt EL UHF Ook wel 1000watt double ended genoemd
Basic CO2 menu
If you press the SET key in the CO2 screen, you can calibrate the
CO2 auto calibrate
# 0.0 °C
sensor automatically. By pressing the SET key again, you
can select Auto Calibrate Yes of No. If you want to calibrate
the sensor, it should be placed in outdoor air for ve minutes
and then press Auto Calibrate/Yes.
Basic Aux/ Fan menu
The following parameters can be set in the basic fan menu:
Fan mode
Temperature
Press SET to change these parameters. Fan mode can be used to choose between the following options:
Temperature > The fan works faster if a certain temperature is reached.
The temperature mode can be used to set the temperature at which the fan must work faster.