Figure 4
Battery
Cover
Battery
Ensure that power is supplied through main service 1.
panel.
Locate manual controls. (Figure 1)2.
Activate On/Off switch.3.
Press and hold the 3-Position Switch in the “4. I” position
for 5-10 seconds. (The rst or second red indicator light
will ash, depending on age of model). (Figure 3)
Press the ON button located on the remote control. 5.
(Figure 4)
This will synchronize the remote control and receiver.
Remote Control Usage
The remote control operates the replace levels
sequentially. The level is increased every time the “ON”
button on the remote control is pressed. The replace can
be turned off at any point by pressing the “OFF” button on
the remote control.
Battery Replacement (Figure 4)
To replace battery:
Slide battery cover open on the remote control.1.
Install one 12-volt (A23) battery in the battery holder.2.
Close the battery cover.3.
Battery must be recycled or disposed of properly.
Check with your Local Authority or Retailer for
recycling advice in your area.
4 www.dimplex.com
To Next Page
Loading...
