Dimplex DF3033ST Owner's Manual

11
not run on the remote operated
thermostat.
!
NOTE: When the manual
control switch is in the Flame
or Flame & Heat positions, the
replace unit will not operate
with the remote control.
C. Initialization Button
Used to synchronize the remote
control with the replace.
Resetting the Temperature
Cutoff Switch
Should the heater overheat, an
automatic switch will turn the
heater off and it will not come
back on without being reset.
The temperature cutoff switch
can be reset by unplugging the
unit, waiting ve (5) minutes and
plugging the unit back in.
CAUTION: If you need
to continuously reset the
heater, unplug the unit and
call Dimplex North America
Limited at 1-888-346-7539
for technical support. Please
have your model and serial
number ready when calling.
Operation
Remote Control
The remote control has a range of
approximately 50 feet
(15.25 m), it does not have to
be pointed at the replace and
can pass through most obstacles
(including walls). It is supplied
with 243 independent frequencies
to prevent interference with other
units.
Battery Installation
① Depress tab on the battery
cover on the back of the remote
transmitter and remove battery
cover (Figure 5).
Figure 5
Batteries
Child Lock
② Install two (2) AAA batteries
into the remote control (included).
③ Ensure child lock is in the
“unlocked” position (Figure 5).

Dimplex DF3033ST Specifications

General

Brand	Dimplex
Model	DF3033ST
Category	Indoor Fireplace
Language	English