Maintenance
Light Bulb Replacement
Allow at least ve (5) minutes for
light bulbs to cool before touching
bulbs to avoid accidental burning
of skin.
Light bulbs need to be replaced
when you notice a dark section
of the ame or when the clarity
and detail of the log ember bed
exterior disappears. There are
three (3) bulbs under the log set,
which generate the ames and
embers, and two (2) bulbs above
the log that illuminate the log
exterior.
Lower Light Bulb Requirements
Quantity of three (3) clear
chandelier or candelabra bulbs
with an E-12 (small) socket base,
60 Watt rating. Example: GE
60BC or Philips 60 CTC.
Do not exceed 60 Watts per
bulb.
Helpful Hints
It is a good idea to replace all
light bulbs at one time if they are
close to the end of their rated life.
Group replacement will reduce
the number of times you need
to open the unit to replace light
bulbs. Care must be taken when
removing the log set as the log
set contains LED’s and wires.
To access the lower light bulb
area:
Figure 8
Upper Bulbs
Log Set
Lower
Bulbs
LED
Wire Harness
Front
Glass
① Remove front glass assembly.
② Pull the front edge of the
plastic ember bed or plastic grate
up and forward until the rear tab
releases from the ledge located at
the bottom of the mirror
(Figure 10).
!
IMPORTANT: Only handle the
log set by the ember bed.
!
NOTE: Log set ts tightly into
rebox, some force may be
necessary to remove.
To Next Page
Loading...
Need help?
General
