Operation
Temperature is higher then
A. Room Temperature the heat
will come on. To turn the heat off,
lower the B. Set Temperature
so that it’s setting is lower then
the A. Room Temperature. The
default temperature setting is
72°F (22°C).
!
NOTE: When using the
remote control the heater runs
on a thermostat. Press the
H. Temperature Up or
G. Temperature Down
buttons to adjust the set
temperature. Once the
desired set temperature is
reached the heater will turn off.
The heater will cycle on and
off to maintain the desired set
temperature.
Child Lock (Figure 7)
Figure 7
Unlocked
Locked
Child Lock Tab
① Depress tab on the battery
cover on the back of the remote
transmitter and remove the
battery cover (Figure 5).
② Move Child Lock tab to
the right to lock the remote
transmitter.
③ Move Child Lock tab back
to the left to unlock the remote
transmitter.
④ Replace the battery cover.
!
NOTE: To temporarily unlock
the remote transmitter press
(in order) G. Temperature
Down then H. Temperature
Up then I. Dimmer Down.
When the remote transmitter’s
backlight is illuminated the Child
Lock is bypassed. When the
backlight is off the Child Lock is
re-activated.
To Next Page
Loading...
Need help?
General
