16
8. Hold the light sockets while unscrewing the bulbs.
9. Remove the yellow wire from the heater element coming from the heater on/off switch.
10. Remove the blue wire from the circuit board coming from the temperature cutoff switch.
11. Remove the (2) element mounting screws from the top of the element located on both
sides of the temperature cutoff switch.
12. Remove the (4) heater assembly mounting screws from inside the firebox and set aside
the heater assembly.
13. Disconnect wiring connections and connect to replacement heater assembly noting their
original locations.
14. Reassemble in the reverse order as above.
To Next Page
Loading...
