Fireplace Installation
①
into the mantel (refer to mantel
assembly instructions).
!
NOTE 1:
circuit is required. A dedicated
circuit is preferred but not
essential in all cases. A
dedicated circuit will be
required if, after installation,
the circuit breaker trips or fuse
blows on a regular basis when
the heater is operating.
Additional appliances on the
same circuit may exceed the
current rating of the circuit
breaker.
!
IMPORTANT: If not using a
must be installed in an
enclosure with the following
minimum internal/opening
dimensions (Figure 1).
New Wall Construction
①
Select a suitable location that
is not susceptible to moisture and
is away from drapes, furniture and
②
desired location to see how it will
look in the room.
③ Mark the desired location on
a safe, dry and dust free location.
④
opening of 31 ¾ inches (807 mm)
wide x 22 ¾ inches (578 mm)
Option #1
be lead from behind the trim and
along the wall to an outlet near
Option #2
installed inside the new frame
construction. Plug the unit into
cord does not reach, you may
use an extension cord rated for a
minimum of 1875 Watts.
Figure 1
To Next Page
Loading...
