MAINTENANCE
Light Bulb Replacement
The light bulbs need to be replaced when you notice a dark section of the
flame. There are two bulbs under the log set which generate the flames and
embers.
Warning
Disconnect the power before attempting any maintenance or cleaning to
reduce the risk of fire, electric shock or damage to persons.
Warning
Ensure the power cord is not installed so that it is pinched or against a sharp
edge and ensure that the power cord is stored or secured to avoid tripping or
snagging to reduce the risk of fire, electric shock or injury to persons.
Construction and electrical outlet wiring must comply with local building codes
and other applicable regulations to reduce the risk of fire, electric shock and
injury to persons.
Do not attempt to wire your own new outlets or circuits. To reduce the risk of
fire, electric shock or injury to persons, always use a licensed electrician.
Cleaning
Glass
The glass is cleaned in the factory during the assembly operation. During
shipment, installation, handling, etc., the glass surface may collect dust
particles, these can be removed by buffing lightly with a clean dry cloth.
To remove fingerprints or other marks, the glass can be cleaned with a damp
cloth using a good quality household glass cleaner. The glass should be
completely dried with a lint free cloth or paper towel. Do not use abrasive
cleaners on glass surface or spray liquids directly onto any surface.
Surface
Use warm water only to clean painted surfaces. Do not use abrasive cleaners
on glass surface or spray liquids directly onto any surface.
Unit storage
Store the unit when not in use in a dry, dust free location with the power cord
properly secured.
4
To Next Page
Loading...
