17
DS5598, DS5603, DS5804
If unit was operating prior to servicing allow at least 10 minutes for light bulbs and
heating element to cool off to avoid accidental burning of skin.
Disconnect power before attempting any maintenance or cleaning to reduce the risk of
electric shock or damage to persons.
TO REPLACE HEATER ASSEMBLY
1. Remove the stove pipe kit (if equipped).
2. With the front door closed, gently place the stove, door side up on a flat surface.
3. Remove the heater assembly retaining screws located on the bottom of the stove
with a screwdriver.
4. Lower the heater assembly off of the bottom of the stove being careful not to
damage any of the wiring.
5. Disconnect the wiring clips and connections noting their original locations.
6. Remove the heater assembly mounting screws and remove the heater assembly.
7. Properly orientate the new heater assembly and connect all of the wiring clips and
connections.
8. Reassemble in the reverse order as above.
To Next Page
Loading...
Need help?
General