Why does the heater fan run continuously on my Dimplex Stove?
If the heater fan on your Dimplex Stove runs continuously, it could be due to loose wiring, a defective heater on/off switch, or a defective heater assembly. Try tracing the wiring in the unit or replacing the heater on/off switch or heater assembly.
Why is the log set dim and the ember bed not glowing on my Dimplex TDS8515 Stove?
If the log set is dim and the ember bed is not glowing on your Dimplex Stove, it is likely due to burnt light bulbs. Replace the light bulbs.
Why is there grinding or excessive noise when the heater is off on my Dimplex TDS8515?
Grinding or excessive noise when the heater is off on your Dimplex Stove could be caused by the moving flame rod hitting or rubbing against internal components, or a defective flame motor. Consider flame rod replacement or replace the flame motor.
Why is the flame frozen on my Dimplex TDS8515?
If the flame is frozen on your Dimplex Stove, it could be due to a defective flame motor or loose wiring. Check the wiring connections and replace the flame motor if necessary.
Why is there excessive noise when the heater is on in my Dimplex TDS8515?
Excessive noise when the heater is on in your Dimplex Stove could be due to a dirty blower assembly or a defective blower assembly. Try cleaning the blower assembly or replacing the heater assembly.
Why does the power cord get warm on my Dimplex TDS8515 Stove?
If the power cord on your Dimplex Stove gets warm, it could indicate a defective power cord. In this case, replace the power cord.
Why does my Dimplex TDS8515 turn on and off by itself?
Your Dimplex Stove may be turning on or off by itself because the remote control has a similar frequency to other remotes in the area or due to radio frequency disturbance from outside sources. Try replacing the hand held remote control.
Is it normal for the heating element to glow red in my Dimplex TDS8515?
Small glowing sections of the heating element in your Dimplex Stove are considered normal. However, if larger glowing sections are causing the heater to trip the thermal cut out, unplug the unit, discontinue use, and replace the heater assembly.
Why is the flame not bright or not visible on my Dimplex Stove?
If the flame on your Dimplex Stove is not bright or not visible, it could be due to burnt light bulbs, loose wiring, or a defective light harness. Replace the light bulbs or light harness and check the wiring connections.
What to do if my Dimplex TDS8515 heater turns off after a few minutes?
If your Dimplex Stove heater turns off after a few minutes, but the flame stays on, it could be due to a build-up of dirt in the heater assembly or Purifire filter, or a defective heater assembly. Try vacuuming or cleaning the heater assembly and cleaning or replacing the filter. If that doesn't work, the heater assembly may need to be replaced.
General| Model | TDS8515 |
|---|---|
| Brand | Dimplex |
| Product Type | Electric Stove |
| Thermostat | Yes |
| Power Settings | 2 |
| Overheat Protection | Yes |
| Remote Control | Yes |
| Timer | Yes |
| Fuel Type | Electric |
| Color/Finish | Black |
| Log Set | Yes |
| Frequency | 50Hz |
| Heat Output | 1.5kW |
| Voltage | 230-240V |
To Next Page
