15
DS8515
for light bulbs and
eating element to cool off to avoid accidental burning of skin.
ny maintenance or cleaning to reduce the risk of
lectric shock or damage to persons.
on a flat surface.
located on the bottom of the stove and
motor assembly by removing the screws on the front
ng connections from the heater and Main
train relief grommet from inside the
in relief
nting hole.
original locations.
10. Reassemble in the reverse order as above.
T
If unit was operating prior to servicing allow at least 10 minutes
h
Disconnect power before attempting a
e
O REPLACE THE POWER CORD T
1. Gently place stove on its back
2. Remove the thermostat knob.
3. Remove the heater cover retaining screws
lower heater/light assembly onto the floor.
4. Remove the reflector rod and
and rear of the heater cover.
5. Located and disconnect the power cord wiri
on/off switch noting their original locations.
6. With needle nose pliers grasp the power cord s
rear panel and push while twisting to remove.
7. Pull the power cord out through the hole in the rear cover.
8. Install the new cord set through the hole in the rear cover by placing the stra
over the cord, hold the strain relief with pliers and slide into mou
9. Connect all of the wiring connections in their
To Next Page
Loading...
