13
DS8515
for light bulbs and
eating element to cool off to avoid accidental burning of skin.
ny maintenance or cleaning to reduce the risk of
lectric shock or damage to persons.
on a flat surface.
located on the bottom of the stove and
motor assembly by removing the screws on the front
ng clips and connections from the circuit board, noting their
d by
art of the stud, push the
8. Properly orient the new circuit board and connect all of the wiring connections
T
If unit was operating prior to servicing allow at least 10 minutes
h
Disconnect power before attempting a
e
O REPLACE THE CIRCUIT BOARD T
1. Gently place stove on its back
2. Remove the thermostat knob.
3. Remove the heater cover retaining screws
lower heater/light assembly onto the floor.
4. Remove the reflector rod and
and rear of the heater cover.
5. Disconnect the wiri
original locations.
6. From inside the fireplace, break off the six mounting studs on the circuit boar
grasping with pliers and twisting on the protruding p
remainder of the studs out through the top panel.
7. NOTE: New mounting studs are supplied with the replacement circuit board.
To Next Page
Loading...
