Dimplex TDS8515 - To Replace Flame Motor;Flame Rod

14
DS8515
for light bulbs and
eating element to cool off to avoid accidental burning of skin.
ny maintenance or cleaning to reduce the risk of
electric shock or damage to persons.
on a flat surface.
located on the bottom of the stove and
r by pulling the end of the rod to the
screws and remove the flame motor.
sembly cover being careful not to damage any of the
ctions on the terminal block and remove the wires
1. Reassemble in the reverse order.
T
If unit was operating prior to servicing allow at least 10 minutes
h
Disconnect power before attempting a
TO REPLACE FLAME MOTOR/FLAME ROD
1. Gently place stove on its back
2. Remove the thermostat knob.
3. Remove the heater cover retaining screws
lower heater/light assembly onto the floor.
4. Remove the reflector rod from the flame moto
left and separating it from the rubber sleeve.
5. Remove the rubber sleeve from the motor shaft.
6. Remove the 2 motor mounting
7. Discard the old flame motor.
8. Lay the stove on its back with the front window facing upward.
9. Remove the bottom heater as
wiring and lay it on the floor.
10. Loosen the flame motor conne
noting their original locations.
1