How to stop my Dimplex DWF1215 Indoor Fireplace heater fan from running continuously?
If the heater fan on your Dimplex Indoor Fireplace runs continuously, it could be due to loose wiring, so trace the wiring in the unit. It could also be a defective heater assembly, so replace the heater assembly.
Why does my Dimplex Indoor Fireplace turn on and off by itself?
If your Dimplex Indoor Fireplace unit turns on or off by itself, it could be due to: * The remote control having a similar frequency to other remotes in the area: Replace the Remote Control and initialize it to the Remote Control Receiver. * Radio frequency disturbance from outside sources: Replace the Remote Control and Remote Control Receiver where necessary, then initialize them. * A defective Remote Control Receiver: Replace the Remote Control Receiver and initialize it to the Remote Control.
Why do lights dim when my Dimplex DWF1215 Indoor Fireplace is on?
If the lights dim in the room while your Dimplex Indoor Fireplace is on, the unit is likely drawing close to the circuit's current rating. Try moving the unit to another outlet or installing it on a dedicated 15 amp circuit.
Why does my Dimplex DWF1215 heater emit an odor?
If your Dimplex Indoor Fireplace heater emits an odor, it could be normal if it's a brief period after the heater is initially turned on, as the heater burns off any dust accumulated during manufacturing or operation. However, it could also indicate a defective heater assembly, in which case you should replace it.
Why does my Dimplex Indoor Fireplace heater fan turn on but there is no heat?
If the heater fan turns on but the Dimplex Indoor Fireplace heater lacks heat, it could be due to improper operation (refer to the Operation Section), loose wiring (trace wiring in unit), or a defective heater assembly (replace heater assembly).
Why is my Dimplex DWF1215 heater turning off after a few minutes?
If the heater is turning off after a couple of minutes of operation, it could be due to a build-up of dirt or dust in the heater assembly. Make sure that the exterior intake louvers and firebox cavity are free of dirt and dust. It could also be a defective heater assembly, in which case you should replace it.
Why my Dimplex DWF1215 Indoor Fireplace does not turn on in Manual Mode?
If your Dimplex Indoor Fireplace is not turning on in Manual Mode, it could be due to several reasons: * Improper operation: Refer to the Operation Section. * No incoming power: Check the Fuse/Breaker Panel. * Defective On/Off Switch: Replace the On/Off Switch. * Defective Switchboard: Replace the Switchboard. * Defective Remote Control Receiver: Replace the Remote Control Receiver and initialize it with the Remote Control.
Why my Dimplex DWF1215 does not turn on in Remote Mode?
If your Dimplex Indoor Fireplace is not turning on in Remote Mode, there might be several reasons: * Improper operation: Refer to the Operation Section. * The remote control may not be initialized: Initialize the remote control. * Loose wiring: Check wiring connections. * The remote control is not working: Install a new battery into the Remote Control and reinitialize the remote control if necessary. * Defective Switchboard: Replace the Switchboard. * Defective Remote Control Receiver: Replace the Remote Control Receiver and initialize it to the Remote Control.
General| Model | DWF1215 |
|---|---|
| Type | Electric Fireplace |
| Fuel Type | Electric |
| Voltage | 120V |
| Heating Area | 400 sq. ft. |
| Flame Effect | Yes |
| Adjustable Thermostat | Yes |
| Remote Control | Yes |
| Overheat Protection | Yes |
| Color | Black |
| Heat Output | 1500 Watts |
| Wattage | 1500 Watts |
To Next Page
