To Next PageTo Next PageWhy does the power cord on my Dimplex DWF3651 get warm?
The power cord of your Dimplex Indoor Fireplace may get slightly warm during normal operation when the heater is on. However, if the cord gets hot to the touch, it could indicate a defective power cord, which should be replaced.
Why does my Dimplex DWF3651 Indoor Fireplace trip the circuit breaker?
If the circuit breaker trips or a fuse blows when you turn on your Dimplex Indoor Fireplace, it could be due to a short in the unit's wiring, in which case you should trace the wiring. Alternatively, additional appliances might be exceeding the current rating of the circuit breaker or fuse. Try plugging the unit into another outlet, or install it on a dedicated 15 amp circuit.
Why does my Dimplex DWF3651 Indoor Fireplace heater emit an odor?
If your Dimplex Indoor Fireplace heater emits an odor, it's normal for a brief period when initially turned on, as it burns off dust accumulated during manufacturing or operation. However, it could also indicate a defective heater assembly, which would require replacement.
Why is my Dimplex Indoor Fireplace making excessive noise with the heater on?
If there's excessive noise when the heater is on in your Dimplex Indoor Fireplace, it may be due to a dirty heater assembly. Ensure that the exterior intake louvers and firebox cavity are free of dirt and dust. Alternatively, it could be a defective heater assembly, in which case you should replace it.
What to do if Dimplex DWF3651 Indoor Fireplace heater is not turning off?
If the heater on your Dimplex Indoor Fireplace is not turning off, first, refer to the Operation Section for proper operation. If the issue persists, it could be a defective switch board, a defective thermistor, a defective relay board, or a defective display/control board. In any of these cases, replace the corresponding part.
How to fix Dimplex Indoor Fireplace flame that is not bright?
If the flame on your Dimplex Indoor Fireplace is not bright or visible, check the wiring connections for any looseness. If the wiring is secure, the issue might be a defective LED light strip or a defective display/control board. In either case, replace the corresponding part.
Why does my Dimplex DWF3651 Indoor Fireplace heater turn off after a few minutes?
If the heater on your Dimplex Indoor Fireplace turns off after a few minutes, it might be due to a buildup of dirt or dust in the heater assembly. Ensure that the exterior intake louvers and the firebox cavity are free of dirt and dust. It could also be due to a defective heater assembly, in which case you should replace it.
How to fix Dimplex DWF3651 Indoor Fireplace firebox that doesn't turn on with the buttons?
If the firebox on your Dimplex Indoor Fireplace doesn't turn on using the buttons, start by referring to the Operation Section for proper instructions. Other possible causes include: no incoming power from the electrical wall socket (check the fuse/breaker panel), loose wiring (check wiring connections), a defective switch board (replace the switch board), a defective display/control board (replace the display / control board), a defective relay board (replace the relay board), or a defective power adapter (replace the power adapter).
What to do if Dimplex DWF3651 Indoor Fireplace heater is not turning on?
If the heater on your Dimplex Indoor Fireplace isn't turning on, first, refer to the Operation Section for proper operation. Other potential causes include loose wiring (check wiring connections), a defective switch board (replace the switch board), a defective heater assembly (replace heater assembly), a defective relay board (replace the relay board), or a defective display/control board (replace the display / control board).
Why do lights dim when Dimplex DWF3651 Indoor Fireplace is on?
If the lights dim in the room when your Dimplex Indoor Fireplace is on, the unit might be drawing close to the circuit's current rating. Try moving the unit to another outlet or installing it on a dedicated 15 amp circuit.
Covers options for placing the fireplace unit on a wall or tabletop.
Guides on how to securely attach the fireplace bracket to wall studs.
Turns the unit ON and OFF using the remote or unit controls.
Controls the ON/OFF state of the flame effect.
Cycles through heat settings: Low Heat, High Heat, and Off.
Adjusts the temperature set point for heating requirements.
Allows disabling the heater function for seasonal use.
Manages different presets of ambient lighting color combinations.
Adjusts the brightness level of the unit's ambient lighting.
Sets an automatic shut-off timer for the fireplace.
Explains how to reset the heater if it overheats.
Instructions for replacing the battery in the remote control unit.
How to clean the partially reflective glass surfaces.
Instructions for cleaning the exterior surfaces of the fireplace.
Recommends professional service for repairs not covered in the manual.
Details the models and regions covered by the limited warranty.
Lists products or regions not covered by the limited warranty.
Specifies the duration and scope of the limited warranty coverage.
Outlines conditions and circumstances not covered by the warranty.
Provides steps for obtaining warranty service, including contact information.
Explains Dimplex's responsibilities for defective products under warranty.
Covers options for placing the fireplace unit on a wall or tabletop.
Guides on how to securely attach the fireplace bracket to wall studs.
Turns the unit ON and OFF using the remote or unit controls.
Controls the ON/OFF state of the flame effect.
Cycles through heat settings: Low Heat, High Heat, and Off.
Adjusts the temperature set point for heating requirements.
Allows disabling the heater function for seasonal use.
Manages different presets of ambient lighting color combinations.
Adjusts the brightness level of the unit's ambient lighting.
Sets an automatic shut-off timer for the fireplace.
Explains how to reset the heater if it overheats.
Instructions for replacing the battery in the remote control unit.
How to clean the partially reflective glass surfaces.
Instructions for cleaning the exterior surfaces of the fireplace.
Recommends professional service for repairs not covered in the manual.
Details the models and regions covered by the limited warranty.
Lists products or regions not covered by the limited warranty.
Specifies the duration and scope of the limited warranty coverage.
Outlines conditions and circumstances not covered by the warranty.
Provides steps for obtaining warranty service, including contact information.
Explains Dimplex's responsibilities for defective products under warranty.
General| Model | DWF3651 |
|---|---|
| Type | Electric Fireplace |
| Fuel Type | Electric |
| Voltage | 120V |
| Heating Area | Up to 400 sq. ft. |
| Flame Effect | Yes |
| Flame Technology | LED |
| Remote Control | Yes |
| Adjustable Thermostat | Yes |
| Overheat Protection | Yes |
| Style | Wall-Mount |
