EasyManuals Logo

Dimplex Q-Rad Series User Manual

Dimplex Q-Rad Series
32 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
10
NOTE:
Your heater may produce some noise during
operation. This noise is caused by the expansion
and contraction of the element as it changes
temperature, and is normal for this type of
product. Whilst the noise produced is usually
very quiet, certain environmental factors can
make it more noticeable, such as hard fl ooring
or minimal furnishings If you believe that the
expansion noise is excessive, please contact us.
NOTE:
Should the heater fail to operate,
this may be caused by the room
temperature being higher than the
thermostat setting.
The heater controls can be easily adjusted by using the six buttons on the User
Interface.
1. The Home Screen shows the options available at each stage
of adjustment. Here the current target temperature (setpoint)
is displayed along with the mode of operation. Any use of the
Advance function will be displayed here, and pressing Enter
will show the functions which are enabled.
The currently active mode of operation is displayed at the top of
the screen e.g. ‘Out All Day’ timer.
When the heater is trying to achieve or maintain a room
temperature, ‘Heating On’ will be displayed, otherwise, ‘Heating O ‘ will be displayed.
When the controller buttons have not been pressed for a long period of time, the display will ‘sleep’ and the text
will disappear. The heater is still on and active in whatever Mode it was set to.
2. Menu - Displays the Main Menu;
- Boost – Activate Boost Mode
- Modes - Set the mode of operation.
- Settings – Time/Date, Temperature units etc.
3. Back returns to the previous screen.
4. The Up and Down buttons are used to navigate through the menus and adjust the required room temperature
on the main screen. The screen colour changes based on the temperature selected, showing deep blue through
to bright red.
5. Enter is used to enter sub menus and to confi rm actions.
6. The Advance button is only used when a Timer Mode is active, it allows the timer schedule to be changed
temporarily by forcing a Heating On period to begin or end early. For more information, see page 16.
Out All Day
21
°
C
Heating ON

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dimplex Q-Rad Series and is the answer not in the manual?

Dimplex Q-Rad Series Specifications

General IconGeneral
TypeElectric Radiator
ThermostatYes
InstallationWall-mounted
FinishWhite
Frost ProtectionYes
Energy Saving FeaturesAdaptive start, Open window detection
Safety FeaturesOverheat protection
DimensionsVaries by model
WeightVaries by model
Warranty2 years
Programming7-day programmable timer
MountingWall Mounted
ModelQ-Rad Series
Power Output500W, 750W, 1000W, 1500W, 2000W
Voltage230V
Energy EfficiencyHigh

Related product manuals