18
PIN Lock Exceptions
It is possible to allow the ‘Advance’ and ‘Boost’ functions to be enabled/disabled when PIN Lock is active.
There are up to 4 exceptions. These exceptions include:
- Advance
• Ability to activate using the ‘Advance Button’
- Boost
• Ability to activate using the ‘hotkey’ listed in the Main Menu
• Ability to modify the Boost Temperature
• Ability to modify the Boost Duration
To confi gure these settings, see section ‘Product Lock Settings’ on page 19..
‘Advance Function’ Operation during UI Lock
If Advance has been enabled during UI Lock, the Advance button will remain active when UI Lock is active. This
will function in the same way it would if the UI was not locked: only if the Heater is Locked into a Timer Mode.
• If Advance is enabled during UI lock, the Advance button will function as normal while the Heater is set to a Timer Mode.
• If Advance is Disabled during UI lock, the Advance button will not function.
‘Boost Function’ Operation during UI Lock
If enabled, Boost will function in the same way as it does when PIN Lock is not active unless modifi cation of Boost
Temperature and Boost Duration have been disabled.
Boost Temperature and Boost Duration will be set to the default values when ‘Boost’ is activated. If either of these
values have been disabled during Product lock, when the user tries to modify them the heater’s display will show the
message ‘Disabled’ and only the default value can be used. The default values can be changed outside of PIN Lock.
To Next Page
Loading...
Need help?
General
