Dimplex TFA36E - Operation; Maintenance

3
MAINTENANCE
 WARNING: Disconnect power before attempting
any maintenance or cleaning to reduce the risk of re,
electric shock or damage to persons.
!
NOTE: Even if the replace is not used regularly, the
battery should be fully recharged at minimum every three
(3) months to prolong battery life.
Partially Reective Glass Cleaning
The partially reective glass is cleaned in the factory during
the assembly operation. During shipment, installation,
handling, etc., the partially reective glass may collect dust
particles; these can be removed by dusting lightly with a
clean dry cloth.
To remove ngerprints or other marks, the partially
reective glass can be cleaned with a damp cloth. The
partially reective glass should be completely dried with a
lint free cloth to prevent water spots. To prevent scratching,
do not use abrasive cleaners.
Fireplace Surface Cleaning
Use only a damp cloth to clean painted surfaces of the
replace. Do not use abrasive cleaners.
Servicing
Except for battery replacement and cleaning described
above, an authorized service representative should perform
any other servicing.
OPERATION
Figure 1
This electric replace is operated by a momentary switch
located on the bottom of the replace, under the right hand
corner (Figure 1-A).
Press the momentary switch to toggle the replace’s ame
effect on or off.
The battery charge LEDs (Figure 1-B) will indicate the
charge level of the battery. The LEDs read green, yellow
and red from right to left. Once the red battery charge LED
is lit, the electric replace should be plugged in to recharge.
The replace can operate while charging.
!
NOTE: The replace will shut off automatically if it is
unplugged during operation. The momentary On/Off Switch
will need to be activated to turn the replace on again.
A
B
Charging Cord