Dinex Perfect Temp - Page 17

16
3) Use the “   “ keys to highlight “Configure Unit”.
4) Press the “YES” key to select.
5) Enter pass code “15037” on the keypad.
6) Display will prompt:
Select: System Setup
Set Meal Parameters
Set Pass codes
Set Time of Day
Reset
7) Use the “   “ keys to highlight “Pass codes”.
8) Press the “YES” key to select.
9) Display will prompt:
Change Pass codes
Supervisor: 4444
User 333
Note: These are the default factory settings.
10) Use the keypad to enter new pass codes.
11) Press the “SAVE” key to store the changes.
12) Press the “CANCEL” key to exit programming.
Programming Time of Day
Notes: 1. All programming is done in military time (0 to 2400) to reduce the chance of
programming errors.
2. You must change the Station Commander manually for daylight savings time.
1) Press the “PROGRAM” key
2) Display will prompt:
Select:
Program Meal Times
Configure Unit
3) Use the “   “ keys to highlight “Configure Unit”.
4) Press the “YES” key to select.