Dinex Perfect Temp - Page 18

17
5) Enter pass code “15037” on the keypad.
6) Display will prompt:
Select: System Setup
Set Meal Parameters
Set Pass codes
Set Time of Day
Reset
7) Use the “   “ keys to highlight “Set Time of Day”.
8) Press the “YES” key to select.
9) Use the keypad to enter a new time.
10) Press the “SAVE” key to store the change(s).
11) Press the “CANCEL” key to exit programming
Resetting the Controller
Note: Resetting the controller will reset “Meal Parameters” to default factory settings and
remove all “Meal Times”
1) Press the “PROGRAM” key
2) Display will prompt:
Select:
Program Meal Times
Configure Unit
3) Use the “   “ keys to highlight “Configure Unit”.
4) Press the “YES” key to select.
5) Enter pass code “15037” on the keypad.
6) Display will prompt:
Select:
System Setup
Set Meal Parameters
Set Pass codes
Set Time of Day
Reset