18
7) Use the “ “ keys to highlight “Reset”.
8) Press the “YES” key to select.
9) Display will prompt:
Resetting the unit will
Destroy all programming information.
Do you wish to continue?
10) Press the “YES” key to complete the resetting process.
11) Press the “CANCEL” key to exit programming.
Meal Times
The meal times programmed are the actual meal times that the Perfect-Temp cart is expected
to be ready for meal service.
When mealtime is programmed, the Station Commander will automatically calculated the
correct rethermalization start time based upon the programmed length of there thermalization
cycle.
For example, if the Perfect-Temp cart is to be ready for meal delivery at 11:00 a.m., and a
rethermalization cycle of 35 minutes is programmed. Then 11:00 is programmed as the
mealtime and the controller automatically starts the rethermalization cycle at 10:25 a.m.
(11:00 minus the 35 minute rethermalization cycle).
A second cart may be programmed for any cart location for breakfast, lunch or dinner. Some
consideration should be given to the programming of the second cart time. The
rethermalization time for the cart and the amount of time needed to change out the carts
needs to be considered.
For example, if the rethermalization time is 35 minutes and you need 5 minutes to get the
carts changed out, Then the second cart meal time should be at least 40 minutes after the first
(35 minute rethermalization cycle plus 5 minutes for changing carts).
Programming Meal Times
1) Press the “PROGRAM” key
2) Display will prompt:
Select:
Program Meal Times
Configure Unit
3) Use the “ “ keys to highlight “Program Meal Times”.
To Next Page
Loading...
