DINGLI JCPT2223RTB - Page 21

OPERATOR’S MANUAL with Maintenance Information
Control Panel
16
Ground Control Panel
1 Display
Diagnostic readout
2 Engine idle select button
Press this button to select the engine idle
setting. Light on indicates high idle is
selected. Light off indicates low idle is
selected.
3 Overload indicator light
Light on indicates when overloaded.
4 Engine start/flameout button
Press this button to start/flameout the
engine.
5 Standstill-Regeneration button
Press and hold this button 2 seconds to
perform a regeneration.
6 Engine diagnostic device
This device could display Engine speed,
fault messages, engine hours and
symbols about regeneration .
7 Engine fault alarm indicator
Light on indicates when Engine ECU send
fault messages.
8 Key switch
Turn the key switch to the platform
position and the platform controls will
operate.
Turn the key switch to the off position and
the machine will be off.
Turn the key switch to the base position
and the ground controls will operate.
9 Red Emergency Stop button
Push in the red Emergency Stop button to
the off position to stop all functions. Turn
the red Emergency Stop button clockwise
to the on position to operate the machine.
10 Platform down button
Press this button and the platform will
lower
11 Lift function enable button
Press this button to activate the lift
function.
12 Emergency lowering down button
Press this button and the platform will
lower
13 Platform up button
Press this button and the platform will lift.
14 Emergency lowering down enable button
Press this button to activate the
Emergency down function.