OPERATOR’S MANUAL with Maintenance Information
Function Tests
25
⊙ Result: The platform should lower.
19 Turn the key switch to platform control and
restart the engine.
At the Platform Controls
Test Emergency Stop
20 Push in the platform red Emergency Stop
button to the off position.
⊙ Result: No functions should operate.
21 Pull the red Emergency Stop button out to
the on position.
⊙ Result: The LED indicator light should
come on.
Test the Horn
22 Push the horn button.
⊙ Result: The horn should sound.
Test Up/Down Functions and
Function Enable
23 Start the engine.
24 Do not hold the function enable switch on
the control handle.
25 Slowly move the control handle in the
direction indicated by the blue arrow, then
in the direction indicated by the yellow
arrow.
⊙ Result: No functions should operate.
26 Press the lift function select button.
27 Press and hold the function enable switch
on the control handle.
28 Slowly move the control handle in the
direction indicated by the blue arrow.
⊙ Result: The platform should raise.
29 Release the control handle.
⊙ Result: The platform should stop raising.
30 Press and hold the function enable switch.
Slowly move the control handle in the
direction indicated by the yellow arrow.
⊙ Result: The platform should lower. The
descent alarm should sound while the
platform is lowering.
Test the Steering
Note: When performing the steer and drive
function test, stand in the platform facing the
steer end of the machine.
31 Press the drive function select button. The
indicator light should turn on.
32 Push the steer mode select button for
steer FS mode (Front Steer mode).
33 Press and hold the function enable switch
on the proportional control handle.
Depress the thumb rocker switch on top of
the proportional control handle in the
direction identified by the blue triangle on
the control panel.
⊙ Result: The front wheels should turn in the
direction that the blue triangle points on the
control panel.
34 Press and hold the function enable switch
on the proportional control handle.
Depress the thumb rocker switch in the
direction identified by the yellow triangle
on the control panel.
⊙ Result: The front wheels should turn in the
direction that the yellow triangle points on
the control panel.
35 Press the drive function select button. The
indicator light should turn on.
36 Push the steer mode select button for
steer FS mode (Rear Steer mode).
37 Press and hold the function enable switch
on the proportional control handle.
Depress the thumb rocker switch on top of
the proportional control handle in the
To Next Page
Loading...
