DINGLI JCPT2223RTB - Drive and Braking Tests

OPERATOR’S MANUAL with Maintenance Information
Function Tests
26
direction identified by the blue triangle on
the control panel.
⊙ Result: The rear wheels should turn in the
direction that the yellow triangle points on
the control panel.
38 Press and hold the function enable switch
on the proportional control handle.
Depress the thumb rocker switch in the
direction identified by the yellow triangle
on the control panel.
⊙ Result: The rear wheels should turn in the
direction that the blue triangle points on the
control panel.
Test Drive and Braking
39 Press and hold the function enable switch
on the proportional control handle.
40 Slowly move the proportional control
handle in the direction indicated by the
blue arrow on the control panel until the
machine begins to move, then return the
proportional control handle to the center
position.
⊙ Result: The machine should move in the
direction that the blue arrow points on the
control panel, then come to an abrupt stop.
41 Press and hold the function enable switch
on the proportional control handle.
42 Slowly move the proportional control
handle in the direction indicated by the
yellow arrow on the control panel until the
machine begins to move, then return the
proportional handle to the center position.
⊙ Result: The machine should move in the
direction that the yellow arrow points on the
control panel, then come to an abrupt stop.
Note: The brakes must be able to hold the
machine on any slope it is able to climb.
Test Limited Drive Speed
43 Press the lift function select button. Raise
the platform approximately 3.5 m from the
ground.
44 Press the drive function select button.
45 Press and hold the function enable switch
on the proportional control handle slowly
move the proportional control handle to the
full drive position.
⊙ Result: The maximum achievable drive
speed with the platform raised should not
exceed 12.5cm/s.
¤ Result: If the drive speed with the platform
raised exceeds 12.5cm/s, immediately tag
and remove the machine from service.
Test the Tilt Sensor Operation
Note: Perform this test from the ground with
the platform controller. Do not stand in the
platform.
46 Fully lower the platform.
47 Drive both wheels on one side onto an
12cm block.
48 Raise the platform approximately 3.5 m
from the ground.
⊙ Result: The platform should stop and the tilt
alarm will sound at 180 beeps per minute.
The platform controls LED readout should
display LL.
49 Press the drive function select button.
50 Press and hold the function enable switch
on the control handle.
51 Move the proportional control handle in the
direction indicated by the blue arrow, then
move the proportional control handle in the
direction indicated by the yellow arrow.
⊙ Result: The drive function should not work
in either direction.
52 Press the lift function enable button.
53 Lower the platform and drive the machine
off the block.