Dini Argeo HLD3000 User Manual

14
P CONT
In this transmission mode the instrument transmits continuously the following data format depending on the functioning
mode:
Totalisation Mode
Counting Mode
Percentage Mode
9. ERROR MESSAGES
ERROR
MESSAGES
DESCRIPTION
RESOLUTION
-
-
-
-
-
-
Over range
Remove weight from the scale
.
Err 4
Zero Setting Error
Upon start
-
up or when the
ZERO
key is pressed, the weight on the
scale exceeds the percentage programmed on the max. capacity.
Remove the excess weight and retry.
Err 5
Keyboard Error.
The keyboard could be damaged
.
Err 6
Input signal greater
than 3mV/V
Indicates that the A/D converter value is greater than the maxim
um
value:
- Remove the weight from the scale if it’s exceeding.
- The load cell or the electronics could be damaged.
RECYCLING INSTRUCTION
The crossed-out wheeled bin on the product means that at the product end of life, it must be taken to
separate collection or to the reseller when a new equivalent type of equipment is purchased. The
adequate differentiated refuse collection in having the product recycled, helps to avoid possible
negative effects on the environment and health and supports the recycling of the materials of which
the equipment is made. The unlawful disposal of the product by the user will entail fines foreseen by
the current regulations.
ST,GS,XXX.XXXXkg
<CR><LF>
<CR><LF>
GS for gross weight, NT for net weight, XXX.XXXX is the weight
PCS:XXXXXXXXpcs
<CR><LF>
<CR><LF>
XXX.XXXX is the Number of pieces
PERC:XXXXX.XX
%
<CR><LF>
<CR><LF>
XXXXX.XX is the Percentage of weight

Dini Argeo HLD3000 Specifications

General

Brand	Dini Argeo
Model	HLD3000
Category	Scales
Language	English