Dini Argeo HLD3000 User Manual

4
1. INTRODUCTION
This manual was created to help you install and learn all about the functional possibilities of the HLD scale.
WARNINGS
The scales should be sited in a location that will not degrade the accuracy.
Avoid extremes of temperature. Do not place in direct sunlight or near air conditioning vents.
Avoid unsuitable tables. The tables or floor must be rigid and not vibrate. Do not place near vibrating machinery.
Avoid unstable power sources. Do not use near large users of electricity such as welding equipment or large motors.
Avoid high humidity that might cause condensation. Avoid direct contact with water. Do not spray or immerse the scales in
water.
Avoid air movement such as from fans or opening doors. Do not place near open windows.
Keep the scales clean.
Do not stack material on the scales when they are not in use.
2. MAIN TECHNICAL SPECIFICATIONS
Model
Plate
dimensions
mm
Capacity
g
Standard
Division
g (*)
HR
Division
g (*)
Linearity
g +/-
Internal
sensitivity
g
Min.
APW
recommended
g
HLD150
Φ
80mm
150
0,02
0,002
0,004
0,0002
0,002
HLD300
Φ
120mm
300
0,05
0,005
0,01
0,0005
0,005
HLD600
Φ
120mm
600
0,1
0,01
0,02
0,001
0,01
HLD1500
140x150mm
1500
0,2
0,02
0,04
0,002
0,02
HLD3000
140x150mm
3000
0,5
0,05
0,1
0,005
0,05
HLD6000
140x150mm
6000
1
0,1
0,2
0,01
0,1
(*) Standard and HR division selectable in weighing phase, through the unit of measure conversion function, see section
6.8.
Stabilisation Time
2
Seconds typical.
Operative Temperature:
0°C
-
40°C / 32°F
-
104°F.
Power supply:
with fitted 240 Vac mains power adapter or with fitted battery
Battery life:
up to
3
0 hours of continuous use.
Recharge time:
12 hours.
Parameter Setup:
Calibration fully digital and programmable from the keyboard
.
Display :
LCD backlit with 6 ½ digits 1
6
m
m high
.
Case:
ABS Plastic.
Zero range:
+/
-
2% of max load capacity.
Auto ze
ro at start
-
up:
+/
-
1
0
%
of max load capacity.

Dini Argeo HLD3000 Specifications

General

Brand	Dini Argeo
Model	HLD3000
Category	Scales
Language	English