⑤ Installation of spark plug
Tip: If there is no torque wrench when installing the spark plug, a better
estimation method is to screw it 1/4-1/2 turns by force after screwing it in place,
but the spark plug shall be screwed to specified torque as soon as possible.
（2）Adjustment of the carburetor
The carburetor is an important components of the engine. The adjustment
shall be carried out by a dealer with professional knowledge, professional
data and equipment, to ensure that the adjustment is proper.
（3）Replacement of oil
WARNING
Do not drain the oil immediately after turning off the generator.
Oil temperature is very high, when operating, take care to avoid scalding.
1）. Place the generator on a horizontal plane surface, to start up the
generator, running for a few minutes, to increase its temperature, and then
shut down the engine and turn the three-in-one combination switch knob to
"OFF";
2）. Unscrew the knob ①, to remove oil cover plate②;
3）. Unscrew oil dipstick ③;
4）. Place an oil pan under the engine, tilt the generator to quickly pour out
oil;
5）. Place the generator to a horizontal plane surface.
ATTENTION: When filling oil, do not tilt the generator frequently to prevent
damage to the power by filling too much oil.
Spark cold torque: 12.5 N.m
To Next Page
Loading...