6）. Refill oil to a proper level;
7）. Tighten oil dipstick, cover external cover plate and tighten the knob.
（4）Air filter
Dirty air cleaner may prevent air from flowing into the carburetor. In order to
prevent failure of the carburetor, please maintain air cleaner regularly. If being
used in a dusty environment, it shall be maintained frequently.
1). Unscrew the knob ①, to remove cover plateof air
cleaner②;
2). Remove screws ③, to remove cover plate of air
cleaner ④;
3). Remove foam cleaner element ⑤;
4). Clean foam cleaner element with cleaning
solvent and blow it dry;
5). Drip a few drops of oil to foam filter element and
squeeze off excess oil. The foam cleaner element
shall be wet, but there shall not be oil dripping;
ATTENTION
Be sure not to twist the foam cleaner
element forcibly to avoid damage.
6). Put foam cleaner element into air cleaner;
Tip: Make sure that the surface of foam cleaner
element is in close contact with air cleaner, and
there shall be no gap leaking air.
Be sure not to start the engine before air cleaner is
assembled, because it will generate excessive toxic
gas and wear the cylinder;
Recommended oil: SAE S10W/30
Oil grade: API standard Model SJ
or higher Volume: 035L
⑤
③
④
To Next Page
Loading...