DINKING DK4000i - Starting Up the Generator; Generator Startup Procedure

11
STARTING UP THE GENERATOR
Remove the load from all output ends;
1.
Switch low idle switch to "OFF";
2.
Turn multi-switch control to "START" position;
Tip: When hot engine is started up, it is unnecessary to close the choke
valve, but turn the combination switch to "RUN".
3.
First gently pull startup handle, until guy cable is hooked tight, and then pull
it with effort.
Tip: When pulling the hand starter, hold generator carrying handle firm, to
prevent the generator from overturning.
4.
After the generator starts, turn multi-swtich to "RUN".
5.
Plug in after started.
6.