Dino-Power DP-X3 - Page 18

16
11. Turn ON/OFF switch to OFF position.
NOTE: Step 12 is for returning paint in
hose to paint pail. One 50 ft (15 m) hose
holds approximately 1 quart (1 liter) of
paint.
12. To recover paint in hose, point gun
into paint pail while holding gun firmly
to the pail.
a. Disengage trigger lock.
b. Pull and hold gun trigger.
c. Turn Prime/Spray valve
horizontal to SPRAY position.
d. Turn ON/OFF switch to ON
position.
e. Continue to hold gun trigger
until you see paint diluted with
flushing fluid starting to come
out of gun.
13. While continuing to trigger gun,
quickly move gun to redirect spray
into waste pail. Continue triggering
gun intowaste pail until flushing fluid
dispensed from gun is relatively clear.
14. Turn pressure control knob to the
low- est setting.
15. Stop triggering gun. Engage the
trigger lock.
Turn Prime/Spray valve down to
PRIME position.
16. Turn ON/OFF switch to OFF position.
Clean the Gun
1. Clean gun fluid filter with water or
flushing fluid and a brush every time you flush
the system. Replace gun filter if damaged.
2. Remove spray tip and tip guard and
clean with water or flushing fluid and a
brush.
3. Wipe paint off outside of gun using a soft
cloth moistened with water or flushing fluid.
A
C
D
Cleanup