15
© 2007 Directed Electronics - all rights reserved
QUICK REFERENCE GUIDE:
To arm the system
■ You can arm the system by locking the doors with your factory keyless
entry transmitter. When the system arms, your will hear a short chirp,
and see the parking lights flash once.
To disarm the system
■ To disarm the system, unlock the doors using your factory keyless trans-
mitter. You will hear two chirps, and the parking lights will flash twice.
Disarming without a transmitter
■ Turn on the ignition. Press the integrated LED/Valet® switch the pro-
grammed number of times within 10 seconds. The system should now
disarm. If it does not, you may have waited too long. Turn the ignition
off and on and try again.
To enter or exit Valet
®
Mode
■ Turn ignition to “run” position, then turn to “off” position. Press and
release the integrated LED/Valet®switch within 10 seconds. The status
LED will light solid if you are entering Valet® Mode, and it will go out if
you are exiting Valet® Mode.
Cut along dotted line and fold for a quick and easy reference to keep in your purse or wallet.
✂✂
✂✂
To Next Page
Loading...
Need help?
General
