© 2004 Directed Electronics, Inc. Vista, CA
2211
5.
RReelleeaassee..
Once the code is learned, the Valet®/Program button can be released.
You can advance from one channel to another by releasing the Valet® /Program button and tapping it to advance
channels and then
HHOOLLDDIINNGG
it. For example, if you want to program Channel Three after programming Channel
One, release the Valet®/Program button. Press it twice and release it to advance to Channel Three. Then press it once
more and
HHOOLLDD
it. The siren will chirp three times to confirm it is ready to receive the code from the transmitter.
CCooddee LLeeaarrnniinngg wwiillll bbee eexxiitteedd iiff::
■ Ignition is turned off.
■ Door is closed.
■ Valet®/Program button is pressed too many times.
■ More than 15 seconds elapses between steps.
One long chirp indicates that Code Learning has been exited.
ttrraannssmmiitttteerr ccoonnffiigguurraattiioonn
The transmitters can be programmed with the Standard Configuration by using the Channel 7 Auto-learn
**
func-
tion in the Transmitter/Receiver
Remote Control Code Learning
. When programmed for Standard Configuration,
the 3-button transmitter buttons are assigned to the following functions:
Button I operates Arm/Disarm/Panic
Button II operates Channel Two
Button III operates Panic
and Buttons operate Channel Three
**NNOOTTEE::
The Auto-learn function cannot be used to program an optional four-button transmit-
ter.For a four-button transmitter, the different channels must be taught to the transmitter
individually.
To Next Page
Loading...
Need help?
General
